06.26.09
Lets see what kind of a mechanic you really are…
Today I pulled the motor. It was amazingly simple to do, but I get ahead of myself. The day started out by me reenacting yesterdays chain of events and adding some variables. I Lifted the rear wheels off the ground, put the car in third gear, and spun the motor. This time the wheels seemed to grab every time I heard the clunk. It was becoming obvious to me that I had not installed the clutch properly. Based on this theory, I shut everything down, disconnected one of the jumpers from the traction pack, removed the pot box, harnessed the motor and removed the four bolts holding the motor to the trans axle assy. I pulled the motor and examined the inside of the bell housing. There was some indication of wear but, it also could have been the ring gear hitting the inside of the bell housing during the installation and, subsequent removal of the motor. I then turned the spline shaft of the transmission by hand to see if it was binding in any way. The spline turned freely. I put the car into third gear and Got Belia to spin one side while my neighbor Frank spun the other in the same direction and I listened and watched the spline move the way it is supposed to. Next I took the clutch off of the flywheel and discovered that unless one has ZERO concept as to how a clutch works or doesn’t pay any attention to whether something is being jammed, it is near impossible to assemble a VW clutch backwards. Alright! But what could it be? I thought, while I have this motor out of the car and just sitting here, why don’t I spin it.
Whirrr Clunk! That’s it! It was the motor. I called Electro Automotive and left a message. Within 10 minutes I received a phone call from Bill Lentfers. I explained the problem and he asked me to send him a capture from the DMOC. I did. Now it is being analyzed. Hopefully this will be something which can be resolved by adjusting some parameters. In the meantime I wait…
